Roberts-radio CRD-37 Manuel d'utilisateur télécharger pdf (Page 13)

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Operating your radio - Search tuning FM

1. Fully extend the wire aerial and press the On/Off button to switch on

your clock radio.

2. Press and release the Function button until the FM band is

selected.

3. Press the Tuning Up button and then press the Alarm/Auto scan

button. Your clock radio will scan from the currently displayed frequency

direction upwards and will stop scanning when it ﬁ nds a station of

sufﬁ cient strength.

4. The display will show the frequency of the signal which has been

found. If RDS information is available, after a few seconds the display

will show the radio station name. The display will also show "St" and

"RDS" on the upper line if the station is received with stereo and RDS

information.

5. To ﬁ nd other stations press and hold the Alarm/Autoscan button as

above.

6. To scan the FM band in a downwards direction (high frequency to low

frequency) press the Tuning Down button and then press Alarm/Auto

scan button.

7. When the end of the waveband is reached your radio will recommence

tuning from the opposite end of the waveband.

8. Adjust the Volume to the required settings.

9. To switch off your clock radio press the On/Off button.

3,6

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Pas de commentaire

Roberts-radio CRD-37 Manuel d'utilisateur Page 13