Roberts-radio RDK-2 Manuel d'utilisateur télécharger pdf (Page 40)

The wire coloured BLUE must be connected to the terminal marked N or

coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L

or coloured RED.

Mains supply

The RDK2 will operate from a supply of AC 230 volts, 50Hz

only.

DO NOT cut off the mains plug from this equipment. If the plug ﬁ tted is

not suitable for the power points in your home or the cable is too short to

reach a power point, then obtain an appropriate safety approved extension

lead or adaptor. If in doubt consult your dealer.

If the mains plug is cut off for any reason, immediately remove the fuse

and dispose of the plug to avoid a possible shock hazard by inadvertent

connection to the mains supply.

If this product is not supplied with a mains plug, or one has to be ﬁ tted,

then follow the instructions given below:

IMPORTANT

DO NOT make any connection to the larger terminal which is marked

with the letter E or by the safety earth symbol

or coloured Green or

Green-and-Yellow.

The wires in the mains lead are coloured in accordance with the following

codes :-

BLUE - NEUTRAL BROWN - LIVE

Fuse

When replacing the fuse only a 3 Amp ASTA approved to BS1362 type

should be used. Be sure to re-ﬁ t the fuse cover.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Replacement fuse holders are available from Roberts Radio Technical

Services at the address shown on the rear of this manual.

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Roberts-radio RDK-2 Manuel d'utilisateur Page 40