Roberts-radio RDK-2 Manuel d'utilisateur télécharger pdf (Page 6)

Fixing instructions

Please read the following installation procedure and familiarise yourself

with each of the steps before starting work. This will help ensure that the

installation proceeds smoothly and without error. You should also read the

cautions on page 40 of this booklet.

1. Determine the desired location for the radio. This must be away from

sources of heat, steam and naked ﬂ ames (away from kettles, toasters,

cooker hobs, and the like).

2. Check that DAB and FM reception is possible at the desired

location.

3. Adjust the aerial for optimal DAB and FM reception. For optimum

reception the aerial may need to run vertically rather than horizontally.

Try to avoid running the aerial near wiring, water pipes, or other metal

structures. You may need to experiment to determine the best position

for the aerial. Use adhesive tape as a temporary ﬁ xing for the aerial,

since holding it may affect reception.

4. Check that the aerial and mains lead can be safely routed and secured

before ﬁ tting the radio.

5. Loosen the thumb screws on the sides of radio to free the mounting

bracket. Lift the mounting bracket and tighten the thumb screws.

6. Offer the radio to the desired location to determine the precise location

of the mounting bracket against the underside of cupboard.

7. Using a soft pencil, mark the underside of the cupboard with the

location of the mounting bracket.

Cupboard

Wall

Cupboard

Facia

strip panel

Mounting

bracket

Radio thumbscrew

225mm

60mm

45mm

Front of radio

A. Front view of radio installed under a cupboard

B. Side view showing radio installed under cupboard which has a

facial panel

C. Mounting hole locations relative to the front of the radio.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Pas de commentaire

Roberts-radio RDK-2 Manuel d'utilisateur Page 6